MA-DISP-FP4x & 6x_EN
Page 4 on 18
Rev: 08/02/2012
3.
GENERAL DESCRIPTION
The main function of this series is to give a clear numeric readout of the variable being monitored.
Various digit heights are available, to suit the maximum viewing distance required in each installation. For
every 10 metres of viewing distance required, use 1” (2,54cm) of digit height.
Various optional output modules are also available to give alarm relay outputs, analogue output or digital
communications, or any combination of these options.
Displays are programmed using front panel pushbuttons. The front panel buttons can be disabled. In addition,
you can connect 4 remote wired pushbuttons to the display, so that you can make adjustments while the
display is mounted in an inaccessible location.
Displays have two power supply options: 100-240 VAC or 11-30VDC
These displays must be installed fully assembled, and must be installed according to local electrical installation
rules.
When properly installed, and provided they have been ordered with cable glands exiting the lower surface of
the case, they provide ingress protection to IP65 / NEMA4X from all directions.
Safety
Caution:
There is a risk of electrical shock if this instrument is not properly installed
Caution:
Risk of danger: Read the whole manual before you install this display
Obey all safety warnings in this manual, and install the display according to local wiring and installation
regulations. Failure to follow these guidelines may cause damage to the display, connected equipment, or may
be harmful to personnel.
Any moving mechanical device controlled by this equipment must have suitable access guards to prevent
injury to personnel if the display should fail.
