Sensus RTM II FlexNet, Руководство пользователя

Страница: 4 / 42

iv Compliance Statements
Document Number Document Name
WARNING
When applicable, there is danger of explosion if batteries are mishandled or incor-
rectly replaced. On systems with replaceable batteries, replace only with the same
manufacturer and type or equivalent type recommended per the instructions pro-
vided in the product service manual.
Do not disassemble batteries or attempt to recharge them outside the system. Do
not dispose of batteries in fire.
Dispose of batteries properly in accordance with the manufacturer's instructions
and local regulations.
WARNING
For products with multiple power cords, all power cords must be disconnected to
completely remove power from the system.
WARNING
For products that use power cords, not all power cords have the same current rat-
ings. Do not use the power cord provided with your equipment for any other use.
Household extension cords do not have overload protection and are not meant for
use with computer systems. Do not use household extension cords with your Sen-
sus product.
WARNING
Sensus products are designed to be connected only to a grounded main circuit out-
let. Do not defeat the plug grounding pin and do not plug these products into a non-
grounded main power circuit.
ATTENTION
This equipment contains components that can be damaged by electrostatic dis-
charge. To prevent unexpected operation or permanent damage, be sure to con-
nect the ground lug to an earth ground and always touch the ground lug before
touching any components inside the enclosure.
ATTENTION
This device complies with Industry Canada license-exempt RSS standard(s). Oper-
ation is subject to the following two conditions: (1) this device may not cause inter-
ference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.
ATTENTION
This radio transmitter (identify the device by certification number, or model number
if Category II) has been approved by Industry Canada to operate with the antenna
types listed below with the maximum permissible gain and required antenna imped-
ance for each antenna type indicated. Antenna types not included in this list, having
a gain greater than the maximum gain indicated for that type, are strictly prohibited
for use with this device.
Le présent émetteur radio (identifier le dispositif par son numéro de certification ou
son numéro de modèle s'il fait partie du matériel de catégorie I) a été approuvé par
Industrie Canada pour fonctionner avec les types d'antenne énumérés ci-dessous
et ayant un gain admissible maximal et l'impédance requise pour chaque type
d'antenne. Les types d'antenne non inclus dans cette liste, ou dont le gain est
supérieur au gain maximal indiqué, sont strictement interdits pour l'exploitation de
l'émetteur.
• Phantom 3dBi