FUNCTION #8: RESTORE FACTORY DEFAULTS
To return a wall switch controller to its original factory default settings, follow the below steps:
1
Enter programming mode by pressing and holding the button for at least
6 seconds
until the LED begins flashing
blue only
, then release.
2
Press and release the unit’s pushbutton
8 times
, wait 2 seconds, then press the button
3 times
.
3
To
Execute
the command and
Exit
programming mode, press and holding the button until the LED changes to
blue
, then release. The LED will then blink white twice as confirmation of
success.
Note:
To Exit without saving during any step, release button and wait until the unit double flashes blue.
FUNCTION #7: LED BEHAVIOUR
When the load controller has switched the lights off, the unit’s LED will be solid blue as a locator. To disable this locator LED functionality, follow the below steps.
SETTING #
DESCRIPTION
2
Locator LED enabled
(default)
3
Locator LED disabled
CHANGING THE LED BEHAVIOUR
1
Enter programming mode by pressing and holding the button for at least
6 seconds
until the LED begins flashing
blue only
, then release.
2
Press and release the unit’s pushbutton
7 times
, wait 2 seconds, then press the button
3 times
to disable location functionality (or 2 times to enable).
3
To
Execute
the command and
Exit
programming mode, press and holding the button until the LED changes to
blue
, then release. The LED will then blink white twice as confirmation of
success.
Note:
To Exit without saving during any step, release button and wait until the unit double flashes blue.
FUNCTION #5: RELAY ENABLE/DISABLE
If the wall switch load controller is being used as a remote switch for another load controller and not controlling a lighting load of its own, the relay can be disabled. To disable, follow the
below steps.
SETTING #
DESCRIPTION
2
Relay enabled
(default)
3
Relay disabled (i.e. always closed)
DISABLING THE RELAY
1
Enter programming mode by pressing and holding the button for at least
6 seconds
until the LED begins flashing
blue only
, then release.
2
Press and release the unit’s pushbutton
5 times
, wait 2 seconds, then press the button
3 times
to disable the relay (or 2 times to enable).
3
To
Save
the setting and
Exit
programming mode, press and holding the button until the LED changes to
blue
, then release. The LED will then blink white twice as confirmation of
success.
Note:
To Exit without saving during any step, release button and wait until the unit double flashes blue.
CONFIGURATION SETTINGS
(CONT.)
