Operating manual Fx9x
.
III. Operation
The
Fx9x SmartRange
sensors are equipped with an LCD display and 3 operating buttons which control all
instrument functions. All parameters can be adjusted and measured values can be read via the integrated serial
interface using PC software or your own special application programme. (Parameters of RS422 interface can only
be altered on the device)
In
measuring mode
:
the text “DIST mm“ or “DIST INCH“ (depending on unit selected)
and the actual measured value are displayed on the screen.
ESC
DIST mm
123456
The three operating buttons have the following general functions
Button
Name
General operating functions
Enter button
General:
Selects function and switches one menu level down –
or
records value and switches one menu level up
In operating mode: Switches to menu level
(If password function is active, switches to password entry. Measuring mode
remains active until correct password has been entered).
When editing e.g. switching points: switches cursor position from right to left
or ends entry when cursor is at the far left.
Right arrow button General: scrolls to the next function (right), or increases current digit by 1
when editing.
In “QuickSet“ menu, it enables the teach-in of Q2
In measuring mode, press this button to make the display light up.
Left arrow button
General: scrolls to the next function (left), or reduces current digit by 1 when
editing
In “QuickSet“ menu, it enables the teach-in of Q1
In measuring mode, press this button to make the display light up.
ESCape
function
Left and right
arrow buttons
simultaneously
Cancels active function and switches to next menu level above
(important: buttons must be pressed simultaneously, previous value is
maintained unaltered)
ESC
Selecting menu items:
Menu items are displayed in two forms:
1.
< Menu item>
, with this display, it is possible to switch to another menu item with , or select the menu
point with .
2.
→
Menu item
, with this display, the keys can be used to alter the value.
Note:
The red pilot laser and the display’s background lighting are always active in set-up mode.
When the sensor is switched on, the following message appears for approx. 2 sec.:
ESC
Fx9x
Rev. nnnnn
The software revision number must always be quoted when contacting the
manufacturer with technical queries.
SensoPart Industriesensorik GmbH, D-79695 Wieden, Tel. +49 (0)7673 821-0 Fax +49 (0)7673 821-30 www.sensopart.de
Page 5
Status 21.10.2004 Software 1.51 and higher 068-13621
