Sensidyne Gilian Gilibrator STABLFLOW, Руководство по эксплуатации, Страница: 10 / 46

© 2018 Sensidyne, LP Sensidyne Document No. 360-0213-01 - Rev B
Page 4
Gilian Gilibrator 3 ® Dry Cell Calibrator – Operation Manual
This product uses rechargeable Lithium Iron Phosphate (LiFePO
4
) batteries. Always
fully charge before use . DO NOT attempt to deeply discharge the internal battery
pack. The internal LiFePO
4
battery pack should be drained to 25% prior to
shipping.
DO NOT open the Gilibrator 3 Dry Cell Calibrator, charge or replace batteries in
an explosive atmosphere.
Use only the charging cable provided for the Gilibrator 3
Dry Cell Calibrator as specified in the Parts List. Battery Pack is nominal 3.2V (3.6V
max.). Caution: Both base and battery may become warm during charging.
Gilibrator 3 batteries may only be replaced by an authorized Sensidyne Service
Center. LiFePO
4
batteries must be promptly disposed of in a manner that corresponds
to local regulatory requirements for Lithium Batteries. Keep away from children. The
battery used in this device may present a risk of fire or chemical burn if mistreated. Do
no disassemble, heat above 140
⁰
F (60
⁰
C), or incinerate. Replace battery with
Sensidyne Battery Pack (P/N 615-1703-011-R) only. Use of another battery may
present a risk of fire or explosion.
Do not disassemble or reconstruct battery pack. The battery pack has safety
functions and a protection circuit to avoid danger. If those have serious damage, the
pack may generate heat, smoke, rupture, or burn.
Do not short-circuit battery pack. Do not connect the + and - terminals with metals
(such as wire). Do not carry or store the battery pack with metal objects (such as wire,
necklace, or hairpins). If the battery pack is short-circuited, excessive large current will
flow and then heat generation, smoking, rupture, or burning will occur. In addition, it
causes heat generation at metals.
Do not incinerate or heat the battery pack. These cause the melting of insulator,
damage of gas release vent or safety function, or ignition of electrolyte. The above
mentioned actions cause heat generation, smoking, rupture, or burning.
Do not reverse-charge or reverse-connect. The battery pack has polarity. In case
the battery pack is not connected with charger or equipment smoothly, do not force
them to connect, but do check polarity of battery pack. If the battery pack is connected
to opposite polarity with charger, it will be reverse-charged and abnormal chemical
reaction will occur. It causes heat generation, smoking, rupture, or burning.
If the Gilibrator 3 Dry Cell Calibrator comes into contact with a destructive substance(s)
it is the responsibility of the user to take suitable precautions that prevent the unit from
being adversely affected. Destructive substances include acidic liquids or gases that
may attack metals, solvents that may affect polymeric materials, other solvents, or
corrosives. Suitable precautions are regular checks as part of routine inspections and
establishing from material data sheets that chemicals known to be present do not have
an adverse effect on the material of the pump (polycarbonate, polyester, silicone,
Buna-N, Neoprene, Stainless steel, brass and epoxy).