11
Putting the ACA 1 into operation
Connecting
the receivers
You can connect two receivers or receiver systems (e.g.
receivers combined via ASA
1, ASA
3000) to the ACA
1. Groups
of daisy-chainded receivers such as
:B'%*%!:B'%%%!
or EM
3732 may
also be connected.
Each receiver system can use up to four diversity pairs of
antennas.
!
Connect the diversity receiver system to the BNC sockets
OUT A
and
OUT B
,
. Suitable 50 ohm BNC cables are
included in the delivery.
Connecting the ACA 1 to the mains
For powering the ACA 1 and the connected RF boosters or active
antennas you require the NT 3-1 table top power supply (see
“Accessories” on page 18).
!
Insert the DC connector of the NT 3-1 table top power supply
into the
DC IN
socket
-
.
!
Plug the NT 3-1 table top power supply into a wall socket.
CAUTION!
Connecting transmitters to the
^cejih dg
outputs can
damage the
electronics of the device!
The outputs are provided for connecting receivers. Connecting
the ACA 1 to transmitters will cause malfunction and could
result in permanent damage.
!
8dccZXidcangZXZ^k^c\VciZccVhidi]Z^cejih#
/
0
Only use the NT 3-1 table top power supply for safe
operation.
.
