WWW.SENIXTOOLS.COM
11
OPERATION
Drive Control
Blade Control
Recoil Starter Handle
Rope Guide
Upper Handle
Handle Connecting Knob
Cable Clamp
Lower Handle
Grass Catcher
Rear Discharge Door
Rear Wheel
Oil Tank Cap
Side Discharge Cover
Mulching Cover
Cutting Height Adjustment Lever
Front Wheel
Fuel Tank Cap
BLADE CONTROL
The blade control is attached to the upper handle of the mower. Depress and hold
against the upper handle to operate. Release it to stop the engine and blade.
WARNING
This blade control is a safety device. Never attempt to bypass its operation.
CUTTING HEIGHT ADJUSTMENT LEVER
This product is designed with dual-lever height adjustment. The height of
front wheel and rear wheel can be respectively adjusted by two cutting height
adjustment levers which locate above the front wheel and rear wheel. To adjust the
cutting height, refer to the assembly section.
MULCHING COVER
The mulching cover is used for mulching purposes. Instead of collecting the grass
clippings in a grass catcher or using the side discharge chute, some mower models
have the option of recirculating the clippings back to the lawn. This is called
mulching. Close the mulching cover when mulching so that the clipped grass can
not discharge from side.
GRASS CATCHER
You can use the grass catcher to collect clippings while you are operating the
mower. Attach the grass catcher following the instructions in assembly section.
When using the grass catcher, make sure the side discharge cover is removed and
the mulching cover is closed. This will contribute the efficiency of grass collection.
SIDE DISCHARGE COVER
Your mower is shipped as a mulcher. To discharge the grass clippings to the side
instead, follow the instructions in the assembly section to attach the side discharge
cover.
WARNING
Keep hands and feet away from the chute area on cutting deck. Refer to warning
label on the unit.
RECOIL STARTER
The recoil starter is attached to the right upper handle. Depress and hold the blade
control handle, then pull the recoil starter rope to start the unit.
DRIVE CONTROL
The drive control is located on the upper handle and is used to engage the drive.
Push the drive control forward to engage the drive for switching the unit to the self
propelled mode. The drive will be disengaged and the unit will return to neutral
position once pressure is released from the drive control.
