ENGLISH - 8/8
SUPPLY AND MODBUS INTERFACE
Electrical power connections are available from both terminals and using the Seneca
DIN guide bus. Connections relative to the MODBUS RS485 interface are instead
available using the DIN rail bus or, after configuring the SW3 DIP-switch to ON,
through terminals 4, 5 and 6.
POWER SUPPLY
19 – 28 V
~
1
50 – 60 Hz
2
10 – 40 V
1 W Max
The power voltage must be between 10 and 40 V
(any
polarity), or between 19 and 28 V
~
. The upper limits must not
be exceeded in order to avoid serious risk to the module
.
The power supply source must be protected from any module
malfunctions using appropriately-sized safety fuses.
TRUE RMS VOLTAGE INPUT
+
IN A
IN B
Max 1200 Vdc
Max 850 Vac
WARNING REFERRED TO GROUND
Current output
Voltage output
5
4
SW3= OFF
4– 20 mA
The output settings
can be modified by
the software.
5
6
SW3= OFF
0 –
10
V
The output settings
can be modified by
the software.
FACTORY SETTINGS
Default conditions for module configuration parameters:
Full scale
1000 V
Analogue output
Current 4 - 20 mA
Communication parameters
38400 8, N, 1 Addr. 1
To change the input scale, set Dip-Switches SW1 as shown in the relevant table and load the configuration
via the configuration software (EasySetup or Z-NET =
ACCESSORIES
Code
Description
Z-PC-DINAL1-35
DIN rail support with power supply terminals P = 35 mm
Z-PC-DIN1-35
DIN 1-slot support for rear connector P = 35mm
CS-JACK-DB9F
PC-Z204-1 serial cable
CONTACT INFORMATION:
Technical support
Product information
t
+
+
