ENGLISH - 2/8
TECHNICAL SPECIFICATIONS
STANDARDS
EN61000-6-4
electromagnetic emissions, industrial environment
EN61000-6-2
. Electromagnetic immunity, industrial environment.
EN61010-1
(safety)
Install a fuse with a maximum capacity of 2.5 A near the module
For voltages over 1000 V , install a 4kV overvoltage protection device
INSULATION
Protection
impedance
N.B: use in environments with pollution degree 2 or lower.
ENVIRONMENTAL
CONDITIONS
Temperature: -20 – + 65°C
Humidity/Altitude: 30 -90% non condensing, up to 2000 m above sea level.
Storage temperature: -20 – + 85°C
Protection rating: IP20
CONNECTIONS
Removable 4-way screw terminals, 3.5 mm pitch for cable up to 2.5
mm2, rear IDC10, for 35 mm DIN bar IEC EN60715
3.5 mm front jack for configuration
4 mm standard bushes
POWER SUPPLY
Voltage 10..40 V
or 19..28 V
~
50 – 60 Hz
Typical absorption 1 W
INPUTS
Voltage: 0/850 V
~
Input impedance 4 MΩ (precision: 0.5%).
Frequency 30 - 60 Hz,
Voltage: 0/1200 V ,
Input impedance 4 MΩ (precision:
0.5%).
Pass-band: 30-400 Hz (-3 dB).
N.B.:
the instrument below 3% of the selected full scale does not give the
correct measurement
OVERVOLTAGE
Category V: up to 300 Vac/dc:
Category III: up to 600 Vac/dc;
Category II: up to 1000 Vac/dc;
For voltages up to 1200 V provide an overvoltage limiter external to the 4
kV device.
OUTPUTS
Current: 0/4..20 mA, max resistance 500 Ω (precision: 0.1%)
Continuous voltage: 0-10 V selectable via the software. Minimum load
resistance: 1 kΩ. (precision: 0.1%)
Temperature drift: 100 ppm/K
Response time for a stepped variation: 1 s from 10 to 90%
CONFIGURABILITY
Baud rate and MODBUS Address via DIP-switch or via software.
Dimensions (LxHxD)
35 x 102.5 x 111 mm (terminals included).
Case
PA6 material, black.
t
Power
Supply
4000 V
~
1500 V
~
1
0.
.40 Vdc / 19..28 Vac
0..1200 Vdc
0..850 Vad
Input
Configuration
port
Output
RS232
RS485
mA / V
