ENGLISH - 4/8
INSTALLATION ON AND REMOVAL FROM THE IEC EN 60715 RAIL
Fig. 1a
19 20 21
Insertion onto the OMEGA IEC EN 60715 rail:
1) Move the two hooks on the back of the module outward
as illustrated in Fig. 1b.
22 23 24 10 11 12
2) Insert the rear IDC10 connector of the module into a free
slot of the OMEGA rail accessory as shown in Fig. 1a.
(insertion is univocal as connectors are polarised).
9 10 11 12
13 14 15 16
3) To secure the module to the OMEGA guide, tighten the
two hooks on the side of the IDC10 rear connector as
illustrated in Fig. 1a.
17 18 19 20
21 22 23 24
Fig. 1b
19 20 21
22 23 24 10 11 12
Removal from the OMEGA IEC EN 60715 rail:
As shown in figure 1b:
1 2 3 4 9
10 11 12
5 6 7 8
13 14 15 16
1) With the help of a screwdriver, pull the two hooks on the
side of the module outwards.
17 18 19 20
25 26 27 28
21 22 23 24
29 30 31 32
2) Slowly extract the module from the rail.
USE OF THE Z-PC-DINAL ACCESSORY
CAUTION
Do not turn the module upside down
and
do not force the insertion
of the IDC10 connector on
the Z-PC-DIN bus. The module's rear IDC10 connector must be plugged into a free slot on the Z-
PC-DIN bus.
The illustration shows the meanings of the various IDC10 connector pins if signals are to be sent via
them directly.
Fig.
1 c
and
Fig. 1 d
show the power connection and RS485 port on the IDC10.
Power supply AC+
GND / RS485 GND
Power supply AC-
RS485 A
1
RS485 B
L/ B
H / A
IDC10
Z-PC-DINAL
SUPPLY AND MODBUS INTERFACE
Supply and MODBUS interface are available via the Seneca BUS.
Access to the Seneca BUS is available via the IDC10 connector, or via the Z-PC-DINAL-35 accessory.
t
