A-4. Paging the target handset from the base unit
NOTE:
A-5. Intercom during a call
(1) If you want to talk to a specific handset, please follow below steps.
N N
INTERCOM
paging
( N N is the ID of target handset)
Once only press INTERCOM key , it Means paging all handsets.
To stop paging, press INTERCOM again.
(2) Target handset: Press any key except END or pick it up if it is
placed on the base unit or on the charger to answer.
(3) Target handset: To end the intercom, press END key or place the
handset on the base unit or on the Charger.
1. Once paging from the base unit, a confirmed melody will sounds if
the base unit receives the response from the handset. If the melody
does not sound, it means that:
(1) The handset is off.
(2) The handset is out of communication range.
While you are using base unit making or answering a call, there are
two methods to talk to the handset but still hold the telephone call.
1. If you want to talk to any handset, please press INT key only. It will
hold the telephone call, send a hold music to the line and base unit
will page all handsets. Any one of the handsets can answer your
paging.
2. If you want to talk to a specific handset, please follow below steps.
HOLD
N N INTERCOM
paging
( N N is the ID of target handset)
The operations keep the telephone line and send hold music to the
line. And the base unit calls the target handset ID N N . Only
handset N N will respond to the paging.
3. During handset and base unit talking, either base unit or handset
can resume the call. In base unit, press directly to resume the
call. In handset, press TALK Key to resume the call.
While you are using base unit making or answering a call, there are
two methods to transfer the phone call to other handsets.
1. Transfer N N or
( N N is the ID of target handset, is for all handset)
A-6. Transfer a phone
2.
HOLD
TRANSFER
N
N
or
(
N
N
is the ID of target handsets, is for all handsets)
3. You can hear the transfer tone " Do, Mi, So " about 30 second, if no
answer from target handset, you can hear feedback tones to alarm
you talking again.
During base unit in standby mode, press or to adjust ring volume.
There are at least 8 steps can be selected.
While base unit in Intercom or speakerphone mode, press or
to adjust the voice volume. There're at least 7 steps can be selected.
There is a Tone/Pulse switch in the rear panel of base unit for you to
select the proper dialing mode.
MEMORY
MEMORY
Flash
N (0~9)
N : flash time
0 : 80ms 3 :300ms 6 :600ms 9 :900ms
1 :100ms 4 :400ms 7 :700ms
2 :200ms 5 :500ms 8 :800ms
1. Set the M/B ratio=40/60
MEMORY
MEMORY
3
2. Set the M/B ratio=33/66
MEMORY
MEMORY
4
MEMORY
or
MEMORY
MEMORY
MEMORY
1
area code (max 3 digits)
.
MEMORY
MEMORY
2
plus country code (max 3 digits)
MEMORY
MEMORY
5
N
N ( N
N : New ID of handset)
B. Setting
B-1. Ring volume
B-2. Voice volume
B-3. Tone/Pulse dialing mode
B-4. Flash time setting
B-5. M/B ratio
B-6. Set Ring Melody
B-7. Set area code
B-8 Set plus code Country code
B-9. Register new handset
18
19
*
*
*
*
