Sena Parani-ESD100V2, Руководство пользователя, Страница: 44 / 61

44
B.3.10. AT+MLIST?

Response

CURRENT MODE:SINGLE CONNECTION MODE


OK

Purpose
Display the current multiple connection mode and connected slave‟s Bluetooth addresses.
Description Display current mode(SINGLE CONNECTION MODE , MULTI-DROP MODE, NODE
SWITCHING MODE) and connected slave Bluetooth address.
Example AT+MLIST?
CURRENT MODE: MULTI-DROP MODE
TASK1
– 000195000001
TASK2
– DISCONNECT
TASK3
– DISCONNECT
TASK4
– 000195000004
B.3.11. AT+BTMODE,n

Response

OK

Purpose
Set operation mode
Parameters n=0: MODE0 (Default)
n=1: MODE1
n=2: MODE2
n=3: MODE3
Description
When the operation status is „Pending‟ currently, change the status to „Standby‟ with
AT+BTCANCEL prior to this command.
To take effect the ATZ must be executed or Powercycle the unit
Example AT+BTMODE,2

OK

ATZ
B.3.12. AT+MULTI,n

Response

OK

Purpose
Set multiple connection mode
Parameters
n=0: Single Connection Mode (Default)
n=1: Multi-Drop Mode
n=2: Node Switching Mode
Description Set single connection mode, multi-drop mode or node switching mode.
B.3.13. +++

Response

OK

Purpose
Convert the operation status of „Connect‟ to „Standby‟
Description
In „Connect‟ status, data from host is transmitted to the other side Bluetooth device, and
any AT command is not accepted but this command, which is not echoed on the screen.
When Parani-
ESD encounters a character „+‟ from host, it stops the data transmission and
waits for next 2 characters. If the next 2 characters aren‟t both „+‟, it restart to transmit data
including the first „+‟ as well. If not, it converts the operation status to „Standby‟.
If the data from host includes „+++‟, it will convert the operation status to „Standby‟. Notice
that Parani-
ESD holds data transmission when it encounters „+‟, until receiving next
character.
„+‟ is an escape sequence character by default, which is changeable by AT+SETESC.