SeMax CDM-810, Руководство пользователя

Страница: 17 / 41

Connecting the CDM-810 to Your
Device(s)
NOTE: You should have determined the mounting
location for the CDM-810 and have installed the unit prior
to connecting it to any devices.
1.
Verify that the antenna provided with the CDM-810 is
pointing up (vertically). If you are using an external
antenna, attach the antenna to the CDM-810.
2.
Taking the CDM-810 in hand, route a RS-232 Serial
Communications Cable from the DB-9 connector on
the CDM-810 to the Serial Communications port on
the computer. (see Fig. 3)
WARNING: Verify that the AC voltage in your home or
office matches the rated AC input voltage of the CDM-810
power supply.
WARNING: Use only the AC power supply that was
provided with the CDM-810. Use of any other AC power
supply could damage the CDM-810 and void your
warranty.
WARNING: Do not overload your electrical wall outlet or
electrical extension cords as this can result in the risk of
fire or electrical shock.
NOTE: Do not allow anything to rest on cords attached to the
CDM-810. Route the AC power supply cord so that it cannot be
abused by people walking on it, pets chewing on it, etc.
3.
After installing the CDM-810, connect the AX-501 or AX-502
to the unit and place a call by pressing the control switch
once. This will dial a pre-programmed number. If you hear a
ring tone in the headset the CDM-810 is properly connected
and has detected the local network service provider.
Installation
and
Connection
RS-232 Serial Communications Cable
CDM-810
50 ohm
Antenna
IBM Compatible
Computer
©
RS-232
CDM-810
Power Supply
Figure 3. - Computer Connection