SEM 2502925, Руководство пользователя

Страница: 20 / 25

B
R E A K T A N K
H
A ND B O O K
06/2015 V4.0
17
!
5. Failures
If the pump is not working or not working properly, check the following points to
determine whether or not repair is needed:
Failure Possible solution Solution
Err 1, tank runs over Tank is running, level in tank too
high. Mechanical float in the tank is
blocked or does not work properly
Release float or check rubber sealing
ring in the float shut off system
(loosen the red swivel)
Err 2, level critacal low Tank leaks or loses water (faster than
tank can be filled) or is drained
empty.
Check the tank for leaks. Check the
tank for siphoning (can occur if tank
is placed higher than pool level)
Err 3, parameter
settings H and L
incorrect
Settings entered incorrectly Check settings in setup menu
The pump runs but
there is no flow, no
Error 2 on display.
Suction pipe is blocked or leaking Check the suction pipe of the pump
(inlet blocked)
The discharge side of the pump is
blocked (by valve)
Release the pressure side or open
the valve.
No reading on the
display
There is no mains voltage. Fuse
defective
Check the mains voltage using
voltage finder or multimeter. Check
the fuse.
Breaktank control defective Replace the control print
Well display readout,
but pump does not
work
Reservoir is empty.
Fuse of the pump is defective
Make sure the reservoir is filled.
Check the pump fuse.
Bath is not refilled,
break tank in order
Float in swimming pool does not
work.
Check float. In service menu, view
parameter 1 or change it from 1 to 0
or vice versa when moving the float
switch. If not, replace the cabling or
float.
In case of other malfunctions contact SEM Water Treatment Technical Department.
Equipment that is contaminated with chemicals or toxic substances that are hazardous to
health is not considered by SEM Water Treatment!