GB
Transmitter programming procedure
81
First press the
STOP
button
and then the
UP
and
DOWN
buttons as well. Keep all
three buttons depressed for
9 seconds, in order to start the
group separation (wait until the
transmitter control light flashes
three
times).
Important:
This transmitter is deleted after the group separation
is completed.
The receiver acknowledges activation of the group separation by
a short movementof the motors of 3 seconds.
Within the 3-second time slot,
stop the movement of the
motor using the
STOP
button
on the transmitter to be learnt.
The transmitter will be learnt
and the receiver will no longer
be in group separation mode.
If the receivers still run in a group, repeat the process for the
relevant motors.
Note:
Group separation is ended either using a control com-
mand from a transmitter that has been learnt or as a result of
successful programming of the new transmitter.
To programme a transmitter which has not been programmed
using the
STOP
button follow the instructions in section 1.1.
9 sec.
1.
2.
3 sec.
Содержание i-R Marki Send Plus
Страница 42: ...Notizen D 42...
Страница 84: ...GB Notes 84...
Страница 128: ...F Notices 128...
Страница 170: ...NL Notities 170...