Selmo
Comfort technology division
“THESIS DUAL”
Electronic control for towel radiator
Rev. 05 July 2015
Selmo
Electronic
Via Pacinotti, 24 - 35030 Rubano
(PD) Italy- Tel +39.049.8976761, Fax +39.049.8976085 -
www.selmo.it
EN
“ROOM THERMOSTAT” MODE
In this operative mode the user can set the desired room temperature through the [+] and [-]
buttons in a range between 10°C and 32°C. For this purpose, the external sensor (4) is used
for measuring the room temperature.
In this operative mode, the display shows the selected “Comfort” temperature.
If the selected temperature is higher than the room temperature, the active heating indication icon (9) is
shown on the display and the heating element is being powered until the room temperature reaches the
selected temperature value. When the room temperature reaches the desired value, the heating element
is switched off and active heating indication icon (9) is turned off on the display.
SUB-FUNCTIONS
The following 5 sub-functions can be selected from any main operational mode through the [Mode] button.
Comfort
Icon “sun” (10); it is the default function (described above)
Night
Icon “moon” (10); it is similar to the "Comfort" function, but the temperature range is
b9°C and 31°C in
“Room thermostat”
mode
and between 29°C and 69°C in
“Towel
radiator mode”
.
Antifreeze
Icon “snow flake” (10); the temperature remains fixed to 7°C in both main modes
(
“Towel radiator thermostat”, “Room thermostat”).
Fil-Pilote
Icon “house” (10); this function (if present) allows the remote control of the device through the
"Fil-Pilote" control unit (see the following page). The "Fil-Pilote" feature is not available in all
models.
Timer-2h
Icon "2h" (10); in this mode the heating element is powered for 2 hours, independently
from the room temperature or the internal liquid temperature. However, for safety reasons
it is prevented that the room temperature exceeds 32°C and that the internal liquid
temperature exceeds 70°C. At the end of the 2h period the device returns into the
operative mode previously selected. It is possible to exit the “Timer-2h” function at any
time by pressing the [Mode] button.
NOTE:
The “Night” temperature is always below the “Comfort” temperature. The “Comfort”
temperature can be set in a range between the currently set “Night” tempe 1°C and
the maximal allowed "Comfort" temperature value (see technical specifications).
Comfort
Night
Antifreeze Fil-Pilote Timer-2h
