SELMI Filler, Руководство пользователя и обслуживания

Страница: 8 / 34

8
1.7. Details of the manufacturer
The machine described in this instruction manual was built
by:
SELMI S.r.l.
Via Statale, 151 – 12069 – S. Vittoria D’Alba (CN) Italia
Tel. 0172.479273 - 0172.479275 - Fax 0172.477814
www.selmi-group.it - info@selmi-group.it
1.8. Identification plate of the machine (CE marketing)
There is a plate, similar to the one shown here, on the
machine, indicating details of the manufacturer, the CE
conformity mark and the machine’s serial number. Always
state this number when communicating with the
manufacturer.
Example of identification plate on the machine structure
TYPE
SERIAL NUMBER
YEAR
WEIGHT
1.9. Identification plate of the CE marking electric panel
(low voltage)
Example of identification plate on electrical panel. For the
correct data, see the data shown in the section on the
machine’s technical specifications.
1.10. Inteded use
Thanks to the microprocessor control and adjustment of the
dosage this machine is able to facilitate and quicken the
injection of the fillings inside the pralines. The piston pump
body is built with a completely cleanable material. The
working environment at the point of injection is heated and
thermoregulated. If the Filler is used with low density fillings it
can reach high levels of productivity.
The mould is placed on a vibrating table to optimise the
injection of the fillings so eliminating air bubbles which could
compromise the shelf life of the product. The filling production
of this machine can reach 300 moulds/hour.
Warning
A use other than that specified is considered
improper. The machine is intended for professional
use only.
Attention
Do not place any small objects near the control panel
or the tank: they could fall and enter the tank, which
would contaminate the product.
1.11. Operating environment
To guarantee proper functioning the machine must be
protected from atmospheric agents. Its ambient operational
temperature should be between 15C° and 35C° with relative
humidity not exceeding 70%.
The working environment must be clean, sufficiently
illuminated and away from an explosive environment.
The environmental characteristics of the installation site are
specified in section 4.
Attention
The machine’s fixed guards have a variety of
openings to allow the internal units to cool. When the
machine is running, make sure that these openings
are not covered by cloths or objects that obstruct
proper air flow.
1.12. Noise level
The phonometric tests carried out on this specific machine
model show an acoustic pressure lower than
70 dB(A).