SelectBlinds CORD LOOP, Инструкции по установке и уходу

Страница: 7 / 35

6
SKEW ADJUSTMENT (IF NECESSARY)
If the shade does not raise evenly, first make sure the mounting brackets are
mounted level with each other.
If the shade is level and it still skews, operate the shade to the full down position.
Prepare a strip of masking tape approximately 5” long. On the side of the shade
opposite of the skewing direction, and as close to the end of the roller as possible,
lift the fabric toward the back of the shade using your fingers and slide the tape
with the sticky side facing the roller up as far as possible. The tape should be
running parallel to the roller.
Roll the shade up and check for skewing. If the shade is still skewing, add
another strip of tape on top of the first one. If the shade is now skewing in the
opposite direction, tear off about 1” of tape from the last strip installed. Tear the
tape off the end closest to the center of the shade.
Place tape at this end
SHADE REMOVAL
To remove the shade, press the tab on the bottom of the right bracket toward the
center of the shade (1).
Slide the right bracket insert down out of the right bracket (2). The left end of
the shade can now be removed from the left bracket (3).
1
2
3