MANUAL DE INSTRUCCIONES
CÓDIGO 80381 REV C
12/2020
Pag.: 28
J
.P. SELECTA s.a.u.
Ctra. NII Km 585.1 Abrera 08630 (Barcelona) España
Tel 34 937 700 877 Fax 34 937 702 362
e-mail:[email protected] - web site: www.jpselecta.es
SAFETY THERMOSTAT
8. Safety thermostat regulation screw (grey).
9. Safety thermostat reset button (white).
Rearming the safety thermostat
Safety thermostat is an element to prevent the temperature from exceeding
a value. If by a fortuitous event the thermostat is triggered, that is, it opens
the power circuit, the heating element will stop working. Usually there is an
indicator light, or an error message, that indicates that the thermostat is in
this position.
If the thermostat is triggered, check that the equipment looks good and it
is not overheating at any point.
To change its status, simply press the white button (9), and you will hear a
“click” that indicates that the thermostat has been reset. If the equipment
has not cooled down sufficiently, the thermostat cannot be reset, and you
must wait for the temperature to drop before it can be reset.
Adjusting the safety thermostat
From factory, the thermostat is adjusted to its maximum temperature. To
adjust the safety thermostat temperature, do as follows:
1. With the equipment connected to the mains, turn the safety ther¬mostat
screw (8) clockwise to the end of the scale, with the help of a flat screw
-
driver.
2. Select the desired safety temperature using the control keys. This tem
-
perature has to be minimum at 3ºC above the working temperature.
3. Turn on the equipment with the Start key.
4. When the equipment is stabilized at the above selected tempe¬rature,
turn the safety thermostat screw (8) slowly to the left until it clicks, and the
red indicator lamp lights up.
5. Stop the equipment and leave it to cool with the lid open for 15 minutes.
6. Select the working temperature by using the temperature selection keys
(minimum at 3ºC below the desired safety tempe¬rature).
7. Turn the equipment on again with the Start key. Once the temperature is
stabilized, the machine is ready to work.
