4. Attach the Kubota bumper extenders (J) to the bumper mount using (2) M8 x 25 Hex Head Bolts. Set the assembly
onto the Kubota bumper and attach using the factory bolts on the Kubota.
3
1
2
Important Notes
To open a clamp, lift up on both levers in the order
above. Orient all clamps so the first clamp lever
opens towards the front of the vehicle. To increase
clamping force, spin the lever clockwise; to decrease
the clamping force, spin the lever counter-clockwise
before locking.
Spin lever to
adjust clamping
force
Clamp Orientation and adjustment
Front of Vehicle
Bumper Mount and Front Clamp Assembly
3. Attach the two front clamps (D) to the bumper mount (C)
using (4) M6 x 16mm bolts, (2) washers and (4) locknuts.
Make sure all clamp levers open away from the vehicle.
6. Attach the Rear Clamp (E) to the Hood Rack
brackets using (2) M6 x 16mm bolts, (2) washers, and
(2) locknuts as shown above. The clamps should open
towards the front of the vehicle.
M6x16mm
x4
Rear Bracket and Clamp Assembly
5. Install the Hood Rack Brackets (F) to the front roll
cage with four M6 x 16mm socket head bolts (4)
washers and (4) locknuts for each side. Point the
bracket towards the front of the vehicle. Do not fully
tighten bolts yet as you may need to adjust when you
put the basket in place.
M6x16mm
x4
M6x16mm
x4
M8x25mm
x2
