4
Riser Assembly
Locking Bolt
7. Note the riser orientation shown above. Insert the 2 Front riser stems into the front riser/light mounting plate a
few inches in. Tighten the locking bolt at the top of the tube with hex key just enough to hold the riser stems in
place. You will tighten after final assembly.
Basket Installation and Adjustment
8. Attach the riser assembly to the front of the hood rack and bolt the two front riser caps in place. Snug the cap
bolts, but keep them loose enough to allow rotation. Make sure all 4 clamps are open, then set the rack in place.
9. Adjust the width of the extendable tubes so they stick out just past the clamps. The hood rack angle can be
adjusted by loosening the bolt on the front riser stems and lifting up or pushing down on the front of the rack.
Adjust clamps and brackets as necessary, then tighten all bolts. We recommend no more than 5% of slope to
the hood rack.
Locking Bolt
