5-15
▼
Setting parameter items
Chapter 5 "SETUP" Menu
SUPPLY PARAM.
■
CENTERING
Aligns a drawing to the center of the paper. (See the figure below.)
This setting is found on the third hierarchy.
<Parameter (choice input method)>
: Default value
OFF
Centering is not performed.
ON
Centering is performed.
For the data which cannot be completely saved in the spool memory,
centering is not available.
■
PAPER TYPE
Allows for setting of the type of paper to be used in the paper feed mode
= continuous mode or optimum mode. This setting is found on the
second hierarchy.
<Parameter (choice input method)>
: Default value
NON-DESIGNATED
Paper type is not specified.
NORMAL PAPER
Allows for normal paper feeding.
TRACING PAPER
Allows for tracing paper feeding.
FILM
Allows for film feeding.
Centering OFF
Paper feed
direction
Cut position
X
Y
Drawing
Centering ON
Paper feed direction
Cut position
X
Y
a
b
a
Drawing
b
a: Varies depending on output drawing.
b: Varies depending on output drawing.
Drawing is positioned at the center of paper.
Downloaded From ManualsPrinter.com Manuals
Содержание LP-1020
