43
ACCELERATOR & BRAKE
11
If the accelerator or brake pedals are not functioning correctly, you may need to adjust the positioning of the volume or replace it with a new one. In
addition, you should apply grease to the gear contacts and spring parts once every three months.
ACCELERATOR & BRAKE
11
●
When working with the product, be sure to turn the power off. Working with the power on may cause an electric
shock or short circuit. However, the unit must be switched on when using test mode. Do not touch any part of the
unit except those areas indicated. Be careful not to damage the wires. Damaged wires may cause an electric
shock, short circuit or present a risk of
fi
re.
●
This work should be performed by site maintenance personnel or other skilled professionals. Work performed by
non-technical personnel can cause a severe accident such as an electric shock.
●
To prevent accidents while working or while operating the product after it has been installed, be sure not to con-
duct any procedures other than those given in this manual. There are cases in which procedures not covered
in this manual require special tools and skills. If a procedure not given in this manual is required, request service
from the of
fi
ce given in this manual or from the point of purchase.
Do not touch the steering wheel when switching the unit on. The steering wheel undergoes automatic initialization
immediately after the unit is switched on.
Be sure to perform volume's move value setting in the Input Test in the Game Test Mode after
replacing or adjusting the Volume.
When the accelerator pedal is not being pressed, the accelerator volume should have a value of 30H or less. When the pedal is being pressed, the value
should be C0H or greater. When the brake pedal is not being pressed, the value should be 35H or less. When the pedal is being pressed, it should be
D0H or more. You can view these values in test mode. Note that the unit must be switched on to use test mode. Do not touch any part of the unit except
those areas indicated when the unit is switch on, as there is a danger of electrical shock or short-circuit. For this task, you will need a Phillips-head
screwdriver (for M4, M5 screws).
Adjusting Procedure
1
On the accelerator and brake pedal unit,
remove the two truss screws and lift off the
front cover.
11-1 FIG. 01
11-1 ADJUSTING/REPLACING THE VOLUME
TRUSS SCREW (2), chrome
M4x8
FRONT COVER
2
Loosen the single screw that secures the
potentiobase, and move the base to adjust the
volume values.
11-1 FIG. 02
SCREW (1)
M5x12, w/fl at &
spring washers
POTENTIOBASE
VOLUME
220-5484
220-5753
3 2 1
WIRE COLOR
OF POT.
(BRAKE)
3 = PINK
2 = BLACK
1 = BROWN
WIRE COLOR
OF POT.
(ACCELERATOR)
3 = PINK
2 = BLUE
1 = BROWN
Содержание Initial D4
Страница 1: ......
