12
ASSEMBLY AND INSTALLATION
6
6-2 TURNING ON THE POWER
●
When connecting the DVD wire connector, check the orientation carefully and connect securely. The connec-
tor must be connected in the proper direction. If it is connected in the wrong direction or indiscriminately at an
incline so that a load is applied, the connector or its terminal pins could break, causing a short circuit or
fi
re.
●
Be careful not to damage the DVD wire by getting it caught between objects, etc. Doing so may cause a short
circuit or
fi
re.
●
The following explanation assumes that the product has been assembled properly as explained above. If there is
an error or if the product operates in a manner other than as indicated below, cut off the power supply immedi-
ately. Failure to do so may result in a
fi
re or electrical shock.
●
If you look directly at the laser beam in the DVD DRIVE, you could suffer vision impairment. Do not look inside the
DVD DRIVE.
●
Do not use or store the DVD DRIVE or DVD wire in any of the following locations, as this may result in serious dam-
age.
[Do not use or store in these locations]
- Anywhere which may vibrate or shock the equipment
- In direct sunlight
- In damp or dusty places
- In places with a sharp change in temperature
- Close to anything that gives off heat (a heater, etc.)
- Close to anything with a strong magnetic
fi
eld (magnets, monitor, speakers, radio, etc.)
- Anywhere that is likely to get wet (kitchen, etc.)
- Anywhere with a slope or incline
- Anywhere with corrosive gas in the air (chlorine, hydrogen sul
fi
de, ammonia, sulfur dioxide, etc.)
- Anywhere with strong static electricity
[Do not use in these locations]
- Close to anything that is highly retentive of heat (carpet, sponge, cardboard, etc.)
- Anywhere that blocks the DVD DRIVE air vent.
YOU DO NOT NEED DVD DRIVE BECAUSE ID4 GAME IS INSTALLED GAME SOFTWARE ALREADY
AT MANUAFACTURE. PLEASE REFER BELOW SECTION WHEN YOU NEED FOR MAINTENANCE OR
FUTURE UPDATE.
Содержание Initial D4
Страница 1: ......
