Seg One AH113, Инструкция по эксплуатации

Страница: 28 / 78

TIMER SETTING(on the remote control)
1. After adjusting the clock, press the TIMER button for a few seconds, " ON" and "00:00" appears
on the display and the HOUR digit flashes.
2. Touch the SKIP/TUNE SEARCH (UP or DOWN) touch plate on the unit (or remote control) to
adjust it.
3. Press the TIMER button again, the MINUTE digit will flash, adjust it by touching the SKIP/TUNE
SEARCH (UP or DOWN) touch plate on the unit once more to confirm and order TIMER ON time.
4. After adjusting "TIMER ON", “ OFF" appears on the display and the HOUR digit flashes.
5. Repeat the above steps 2 to 3, and then press the TIMER button once more to confirm and order
TIMER OFF time.
6. Now the "TUNER" appears on the display with flashing, and then select the alarm mode of the
“TUNER, CD, USB, CARD or iPod” by touching the SKIP/TUNE SEARCH (UP or DOWN) touch
plate.
7. Press the TIMER button again, the timer "VOL-13” indicator appears on the display and flashes,
adjust the timer volume high or low by touching the SKIP/TUNE SEARCH (UP or DOWN) touch
plate.
8. Each enable state as shown above will be cleared if the button is not pushed in 10 seconds.
9.After adjusting "TIMER ON" and "TIMER OFF" ,press the TIMER button, " " appears on the
display.
10.The main unit will be switched on automatically at "TIMER ON" order and start playing, the main
unit will be switched off automatically at "TIMER OFF" order.
Note: If the display shows "ERROR" while you set the “TIMER ON” it means both “TIMER ON” and
“TIMER OFF” is the same. In this case, please go to “TIMER OFF” to set the off time first.
FUNCTION SELECT
The function is that when it touches the FUNCTION touch plate on the unit or press the FUNCTION
button on the remote control to change the mode of each function. Display changes as below:
RADIO OPERATION
1. Touch the FUNCTION touch plate on the main unit or press the FUNCTION button on remote
control to TUNER mode that to select the FM operation.
2. Touch the SKIP/TUNE SEARCH(UP or DOWN) button on the remote control to tune the desired
wave band range of frequency.
Manual Tuning
To tune for weak stations, use manual tuning by touch the SKIP/TUNE SEARCH(UP or DOWN) button
continuously until you read the correct frequency or the reception is at its best.
Automatic Tuning
1. Touch the SKIP/TUNE SEARCH(UP or DOWN) touch plate on the unit or press the SKIP/TUNE
SEARCH(UP or DOWN) button on the remote control for a seconds or more, then release the
button. The tuner will automatically search the first station of sufficient signal strength.
2. Repeat above procedure if you wish to select another station.
Mono/stereo select
You can select the MONO/STEREO only in FM mode.
1. When you want to select FM stereo station, press the ID3/FM MO./ST. button on the remote control.
When you receive a FM stereo station the " " indicator will appear on the display, you can
receive FM stereo transmission.
2. When you press the ID3/FM MO./ST. button on the remote control again, the FM STEREO
indicator will turn off and switch to MONO FM status.
Programming preset stations
You can also preset stations of your choice and store up to 30 FM stations in its memory. To store
your selected broadcasting stations:
UK-8