Seg KM 1025, Инструкция по эксплуатации

Страница: 45 / 56

45
7. Open the lid of the water tank (13) and pour the water into the water tank (12).
8. Close the lid of the water tank (13).
9. Place the coff ee pot (6) on the hot plate (8).
10. Connect the device with the power supply. The device turns on and time and the
current settings appear in the LC display.
11. Press the button ‘MAHLWERK AUS’ (18). The LED light next to the button lights up to
confi rm that the grinder is turned off .
12. Press the On/Off button (20). The LED lamp next to the control button lights up to
confi rm that the device is ready for the brewing process. With the start of the brewing
the symbol appears in the LC display.
13. The completion of the brewing process is confi rmed by the sound of 3 beep tones,
the symbol in the LC display goes out.
14. When the brewing process is completed the keep warm function of the hot plate (8)
is automatically activated for 35 minutes. After 35 minutes the device turns off
auto matically. If you do not want the keep warm function, press the control button
On/Off (20).
5.3 Automatic Start Programme
NOTE!
Ensure that the device is properly prepared for the pre-set time of brewing, otherwise the
device may be damaged.
The automatic start program executes once at the pre-set time with the settings made.
The desired automatic start program must be re-programmed each time.
1. Set the desired coff ee brewing adjustments, see chapter 5.1 – BREWING COFFEE
WITH COFFEE BEANS or chapter 5.2 – BREWING COFFEE WITH GROUND COFFEE.
2. Set the desired automatic starting time when the device should begin the brewing
process. Press the button ‘PROGRAMM’ (17) for 2 seconds until the blinking time
appears in the LC display.
3. Press the buttons ‘STUNDE’ (22) and ‘MINUTE’ (23) to set the desired automatic
starting time in the 24 hour mode.
4. Press the ‘PROGRAMM’ button (17) again to confi rm the time setting. The LC display
again shows the current time and a clock symbol . The LED lamp next to the
‘PROGRAMM’ button (17) lights up to confi rm the activation of the automatic start
function.