SEELEY INTERNATIONAL AIRA DU SD Series, Инструкция по установке и эксплуатации

Страница: 19 / 60

DU/SD SERIES INSTALL OPERATION MAINTENANCE MANUAL | 17
INSTALLATION INFORMATION
3.2.8 Flue Connections
Units are proved with a short section of flue which is designed to suit the heat exchanger, draft diverter and rain collar.
It is the installers responsibility to provide additional lengths and orentations of flue to ensure that the flue terminates in
a location that is compliant with AS5601.1 and local regulations and requirements. Flue cowls supplied are certified by
AGA independent of the unit, so may be suitable for use on different length flues in accordance with AS4566-2005 Flue
cowls – Gas Appliances.
The flue is to be secured to the spigot with sheet metal TEK type screws. If a different flue design is used the flue up
draft must be confirmed after appliance if started to ensure adequate flow. Flue temperatures are expected between
250 to 300 Deg C. and may require additional flue skins especially when penetration through walls, roofs, floors, etc.
Figure 7: Duct Connections
Figure 8: Flue Connections
AMI119-A
3.2.7 Duct Connections
The outlet of the unit is provided with a 40mm flange for Ductmate® or similar ductwork connection. An inspection and
service panel is located above and below the duct connection flange. Duct connection should be in a manner which
maintains panel operation without the need to remove ductwork.
Refer to the Model Variants and Dimensions section of the document for specific unit details.
G
B
C
K
L
C
B
H
A
I
J
E
C
D
113 113
F
B
A
113
113
EQ EQ
111.2 111.2
AMI138-A SIDE
B
K
H
C
L
FLUE COWL
FLUE
RAIN COLLAR
ROOF SPIGOT
DRAFT DIVERTOR
SPIGOT