SecurityMan CARCAMMICRO, Руководство пользователя

Страница: 12 / 42

8
ATTACHING THE BRACKET
To attach the suction cup mounting bracket, simply push the small square shaped nipple into the
small opening located at the top/front of the camera. You can easily detach the camera when
needed by reversing the step.
MOUNTING THE CAMERA
Please make sure that you are following the regulations and laws set by your states DMV
(Department of Motor Vehicles) prior to mounting your camera. This will avoid any accidents
and traffic violations that can occur if the camera is mounted in a location that is prohibited by
law.
NOTE:
According to CA VC Section 26708 (13) (A) “A video event recorder with the capa-
bility of monitoring driver performance to improve driver safety, which may be mounted in a
seven-inch square in the lower corner of the windshield farthest removed from the driver, in a
five-inch square in the lower corner of the windshield nearest to the driver and outside of an
airbag deployment zone, or in a five-inch square mounted to the center uppermost portion of the
interior of the windshield. As used in this section, “video event recorder” means a video recorder
that continuously records in a digital loop, recording audio, video, and G-force levels, but saves
video only when triggered by an unusual motion or crash or when operated by the driver to
monitor driver performance.”
The first thing you want to do is determine where you will be mounting the camera. The
following diagram depicts mounting locations on a vehicle based in the state of California and
its restrictions.