5
8
Sequence PIP mode.
IMPORTANT: The alarm sensor function is disabled in PIP Sequence Mode
for PIP Sequence mode:
-
-
-
-
supplying power,
to select
cameras
Full screen mode is now active (FIG-8)
Quad mode is now active
to return to QUAD mode
will
TWO-WAY INTERCOM FUNCTION
to
One camera full screen mode is now active
and speak into the microphone (to the left of the talk button)
to listen to the camera audio
14. PIR ALARM FUNCTION
1) Press the SENSOR button on the front of the monitor. A red LED will indicate
when the sensor is active. With the sensor active, motion in front of the camera will
alarm the monitor. The camera with motion activity will automatically appear full
screen on the monitor. An “A” will be displayed on the monitor screen to indicate the
camera with an alarm condition. If more than one camera has motion activity at the
same time, the monitor will enter QUAD mode. All alarmed cameras will display an
“A” on screen. An optional alarm sound can be heard when motion is detected.
The user can activate the alarm sound in the setup menu under DISPLAY MODE -
ALARM SOUND and change the length of the audible alarm under ALARM
LENGTH. See page 11 for adjusting the alarm sound and alarm length.
15. STANDBY FUNCTION / STANDBY SWITCH
1) The standby switch turns the CRT (monitor tube) off while all other monitor
functions remain active. This function saves energy and extends CRT life (when
direct monitoring is not required). If the PIR ALARM SENSOR is active and motion is
detected, the CRT will activate and display an image during the alarm duration. At
the end of the alarm, the CRT will turn off. To turn the monitor off completely, use the
main power switch on the monitor’s back panel.
System operation
System operation (cont.)
will blink,
to select the desired main picture channel
is blinking, then press
to select the desired sub-picture channel(s)
to save and exit
to view the camera full screen
