Security Command XRSuper6, Руководство пользователя

Страница: 11 / 39

XRSuper6 Arming and Disarming 7
Arming and Disarming
All/Perimeter System Arming
Area Assignment: Your security system is divided into two separate
areas. Motion detectors, inside doors, and other interior
protection devices are assigned to the
Interior area while windows
and exterior doors are assigned to the Perimeter area.
Perimeter or All: When arming an All/Perimeter system, the keypad
displays PERIM ALL. If you select ALL , you arm both the
Perimeter and the Interior of the system. You will want to arm
both of these areas when leaving with nobody left inside.
Selecting
PERIM arms only the Perimeter of the system. Perimeter
arming is for when you are staying inside but want the comfort of
knowing the exterior doors and windows are armed.
System Ready/System Not Ready Keypad
Displays
When all zones in the system are in a normal condition, the keypad
displays
SYSTEM READY . If there are one or more zones that are
not in a normal condition, the keypad displays SYSTEM NOT READY .
Pressing any top row Select key during this display shows the
zone name allowing you to investigate the problem.
Instant Arming
Instant: During the exit delay time, you can cancel the exit and
entry delays and cause all zones to be instant zones. Press the
far right select key under
INSTNT while the exit delay is displayed.
This immediately arms the exit zones. However, no entry delay is
provided and an alarm will occur should an entry door be opened.
Arming an All/Perimeter System
1. Enter your code. The keypad displays PERIM ALL .
2. Select PERIM to arm the Perimeter area only or select ALL to
arm both the Perimeter and Interior areas.
The keypad displays any bypassed zones and 24-hour zones
that are in a bad condition. No action is required by you.
3. At this point you can force arm or bypass any bad zones. A
zone that is force armed will be restored into the system if it
later returns to normal. A zone that is bypassed will remain
bypassed until the system is disarmed. See below.
3a. If a problem exists on any zones, the zone name and
problem are shown followed by: OKAY BYPASS STOP .
3b. Select OKAY to force arm the zone(s) before arming.
3c. Select BYPASS to bypass the zone(s) before arming.
3d. Select STOP to stop the system from arming. Correct the
zone problem(s) and return to step 1.
The keypad displays PERIMETER ON if only the perimeter is
being armed and ALL SYSTEM ON if both the perimeter and
interior are being armed.
The keypad next displays
EXIT: ## INSTNT and begins to count
down the number of seconds remaining for you to exit. When
the delay expires, all zones are armed.
4. You can select INSTNT while EXIT: ## INSTNT is displayed to
immediately arm all zones and make them instant. The keypad
displays
INSTANT.
5. When the system is fully armed, the keypad displays PERIMETER
ON for perimeter arming and ALL SYSTEM ON for perimeter
and interior arming.
Technical Manuals Online! - http://www.tech-man.com