Security Chimneys International EPA BIS ULTRA, Инструкция по установке и эксплуатации

Страница: 40 / 43

35
4.8 INSTALLATION INSTRUCTIONS FOR MASONRY APPLICATION
WARNING : Before starting the installation, the masonry chimney must be inspected by
a qualified sweep.
The following requirements must be respected:
1.
The chimney must be absolutely clear of any soot residue or creosote. Check for cracks, loose or missing
bricks that could inhibit correct installation of the liner.
2. The clearance to combustible must be a minimum of 1" between the outside of the masonry and any wood
framing or loose insulation.
3. The chimney must be built in accordance with the current building code.
4. No other appliance can be connected to the same chimney.
5. The clearances to combustible for the BISUMA or BISPMA and BISUMA30 or BISPMA30 connectors are 2"
on the side and bottom and 16" at the top.
6. The connector parts are not necessary if the connection between the insulated length and the stainless
steel liner is done within the masonry chimney .
Installation:
The chimney must be relined with a stainless steel liner model Tubinox or Projet SS of the same diameter as
the outlet of the fireplace.
For connection at 45º angles, a special connector (BISUMA for the BIS Ultra fireplace or BISPMA for the
BIS PANORAMA fireplace) must be used to connect the liner to the insulated chimney. For connection at
30º, use the BISUMA30 or BISPMA30 connectors.
Follow these steps:
1- Position the fireplace in its location. Temporarily
install the ASHT+ elbow on the top of the fireplace
and, using a level, mark with an oval the location
where the flue liner will enter the masonry chimney.
2- In the middle of the oval, drill a hole in the masonry
chimney at 45º or 30º.
3- Increase the size of the hole until a 45º or 30º
Tubinox liner elbow can be easily slipped through.
4- Slide the liner down from the top of the masonry
chimney until you reach the hole level.
5- Slip through the hole a 45º or 30º liner elbow and
connect it to the liner.
6- Add a small liner section to the liner elbow that will
allow the liner to extend at least 12” (measured at the
top of the liner) from the masonry chimney.
7- Seal the opening around the liner with high
temperature refractory cement.
8- The next steps must be done in the following order:
A. Select the ASHT + length that will fit between the
elbow and the liner so that it will slide at least 2
"
over the liner section. (You may need to cut the
liner for a better fit).
See typical installation illustrated below .
B. Take that section and the BISUMA or BISPMA (BISUMA30 or MISPMA30) cover and slide it over the
liner. Make sure you have enough opening to be able to install the ASHT+ elbow without difficulty.
C. Install the 45º or 30º elbow on the fireplace.
D. Slide the length section back down on the elbow and twist lock the two together.
E. Pull the cover down over the length and install the insulation pad over the liner; be careful to cover the liner
completely.
F. Slide back the cover over the insulation and fix it in place using the 3 metal screws supplied .