Security-Center TV7202, Руководство по установке

Страница: 9 / 58

Resetting system settings
In the opening next to the I/O terminal block is a button. Press this button to reset the system or restore the factory
parameter settings. If the system cannot be not installed or is not working normally, use the pointer supplied and
follow these instructions for restoring the initial (factory) status of the system.
Insert the pointer in the hole and press the reset switch. Keeping the switch pressed, restart the system by
disconnecting and reconnecting the transformer. The system runs the self-test twice instead of the usual once, which
you can see by the flashing LEDs. After the second flashes of the LEDs, remove the pointer to release the reset
switch. The factory-set parameters are now restored.
Transformer
Connect the transformer to the voltage in socket of the video server (12V DC).
Switching on
Before installing further video servers, make a note of the serial numbers for future reference.
Before connecting up, all peripheral devices must be switched off. Use the cable supplied to connect the video
server to the peripherals as described below.
Important: Do not switch on the transformer until all other cables have been properly connected.
Make sure that all cables are correctly connected before switching on the video server. Switch on the cameras,
sensors and alarm device and then plug the transformer of the video server into the mains wall socket. If the self-test
is successful, the network speed and the video modulation mode are automatically detected. When the addressing
procedure is complete, the video server is ready to use. If the video modulation mode could not be detected, the
administrator can change the setting on the configuration page. For further information, see the section “System
configuration”.
9