ProLogic L66
Operation Instructions
2
16.0 Recovering the System – Reset to Default
16.1 Recovery Code Set
16.2 Recover System
16.3 Disable Recover
16.4 Mechanical Reset
17.0 System Testing
17.1 Cycle Testing
17.2 Hardware Testing
18.0 Menus
18.1 The ProLogic L66 Menus
IMPORTANT: It is imperative that all programming be completed with the safe
door in its open position, such that the programmer can gain access to the lock
body in the event of an incorrect programming.
1.0 System Installation
1.1 System Components
The system consists of (1) EntryPad – Part # EC-0601A-L66 plus (1) or more Lock bodies as follows:
SwingBolt – Part # EL-0601
SwingBolt with Status Sensor – Part # EL-0601-S
DeadBolt – Part # EL-0701
SpringBolt – Part #EL-0801
Note: The ProLogic L66 can control up to 4 locks when used in conjunction with the Expansion Box –
Part # CB11-1T4. (If setting up a multi-lock system, please refer to Section 11.2 – Multi-Lock Systems)
1.2 Pairing the EntryPad and the Lock
SecuRam safe lock systems can operate in two different modes depending upon the type of EntryPad
being used with the lock body. The ProLogic L66 is a digital lock system and therefore the lock must also
be programmed in digital mode. Both modes follow the same steps to reset / set which is done by
following the steps detailed below:
Step 1: Ensure the battery is connected to the Entry Pad.
Step 2: Ensure the lock cable is disconnected from the lock body.
Step 3: Locate the Reset Hole on the back of the lock (under the QC sticker).
