PROGRAMMING STEPS
To program the Radio Key
®
RKDT-SA-M/SA-S, you must first
enter the program mode as described in the next section below.
Once in the program mode, the LED will blink amber as an
indicator. To take the unit out of program mode you may select
an operating mode (see page 17) or simply allow 15 seconds to
elapse without presenting a program card to the reader.
After you have completed a proper program sequence, the
unit will beep and the LED will flash green to indicate that the
program instruction has been accepted. A red light and a beep
at the end of a programming sequence means that you have
made an error. Refer to the appropriate section, and carefully
re-enter the command in the proper sequence.
NOTE:
Card ID Number and other values in the following
examples are for demonstration purposes only;
enter the appropriate values for your system.
To Enter Program Mode:
Using your programmer, enter your password and then
press “ENTER”. (All new units are pre-programmed with the
Radio Key
®
RKDT-SA-M/SA-S Operating Guide
Secura Key
8
