Q7-B03
Q7-B03 User Manual - Rev. First Edition: 1.0 - Last Edition: 1.1 - Author: S.B. - Reviewed by G.G. Copyright © 2017 SECO S.r.l.
57
4.3.15
Embedded Controller submenu
Menu Item
Options
Description
Watchdog
Disabled / Enabled
Enables or disables the Watchdog. When enabled, the following parameters will appear.
Watchdog action
System Reset
Power Button 1s
Power Button 4s
(Shutdown)
Action executed at the firing of the watchdog timeout.
Delay to Start (Sec.)
[0..600]
Seconds of delay before the watchdog timer starts counting.
Timeout (Sec.)
[20..599]
Watchdog Timeout.
Watchdog Event
Disabled / Enabled
High Active output watchdog event indicator
Ext. PWM Frequency (Hz)
[1..65535]
Sets External PWM Frequency in Hertz
Ext. PWM DC (%)
[0..100]
Sets external PWM Duty Cycle (%)
Ext. Tacho Configuration
3-Wire
4-Wire
Sets External Tachometric FAN Type
LID_BTN# Configuration
Force Open
Force Closed
Normal Polarity
Inverted Polarity
Configures the LID_BTN# signal as always open or closed, no matter the pin level, or configures the pin
polarity: High = Open (Normal), Low = Open (Inverted)
LID_BTN# Wake Configuration
No Wake
Only From S3
Wake From S3/S4/S5
Configures LID_BTN# wake capability (when not forced to Open or Closed). According to the pin
configuration, when the LID is open it can cause a system wake from a sleep state.
SMB_ALERT# wake
Disabled / Enabled
Enables or disables SMBUS Alert Wake from Suspend State.
Int. LAN wake
Disabled / Enabled
Enable wake for internal LAN
External PCIE wake
Disabled / Enabled
Enable wake from Q7 edge connector's PCIE_WAKE# pin
User Non Volatile Storage Content
Open a page showing the user Non Volatile Storage Area Contents
