Secabo T120 II, Руководство по эксплуатации

Страница: 14 / 26

Press the "OK" button to leave the configuration menu at any time.
These settings are queried in sequence
​ :
● Baud rate ­ configurable to 38400, 57600, or 115200, depending on the value configured
for the interface on the computer ­ only when connecting via serial port.
● XP and YP ­ in the second and third menu point, you can calibrate the vinyl cutter correctly.
Correction may be required here due to wear to the mechanical parts. The X and Y scaling
of the data can be changed by changing the XP and YP values. If, for example, an object
for which a length of 100cm was entered on the computer is cut on the vinyl cutter to a
length of only 98cm, it is necessary to correct the corresponding scaling value on the
plotter. Otherwise, these values should not be changed.
● Tool Offset X and Y ­ in the fourth and fifth menu point, you can adjust the offset between
the LAPOS Q sensor and he focal point of the knife holder on the hardware side. However,
since the values are determined by the DrawCut PRO software during a simple calibration
procedure described below in detail, it is not recommended to change the factory settings in
this menu point.
● Sensitivity ­ this menu allows for adjusting the sensitivity of the LAPOS Q sensor to be
adapted to different types of media should there be any problems when reading the
marks. In principle, a lower value is better suited for shiny media and a higher value for
matte media. Only change in case of problems with reading marks.
● Fan setting – here you can adjust the speed of ventilator for the vacuum by choosing one of
three settings or turning it off.
● Reset settings ­ here you can restore the vinyl cutter's factory settings. To do so, the right
arrow key must be held for 3 seconds.
● Firmware ­ here you can view the firmware version installed on the cutter.
Secabo GmbH | Hochstatt 6­8 | 85283 Wolnzach | Germany | mail@secabo.com | www.secabo.com
14