14
6.6
Other Settings
It is possible to scroll through other configuration menus in the offline mode by
pressing the menu key a number of times.
In the settings menu it is possible to adjust the idle speed of the cutting head (Ur), as
well as the Baud rate (Br). The Baud rate set must be identical with the Baud rate set
on the computer. This value must be set to 38400.
The vinyl cutter can be calibrated correctly in the scaling menu (Set Per). Correction
may be required here due to wear to the mechanical parts. The X and Y scaling of
the data can be changed by changing the Xp and Yp values. If, for example, an
object entered with a length of 100 cm on the computer is cut on the vinyl cutter to
a length of only 98cm, it is necessary to correct the corresponding scaling value on
the plotter.
Otherwise, these values should not be changed.
6.7
Limit Switches
If a plotting job is sent to the vinyl cutter accidentally which is larger than the
maximum cutting width of the plotter, the cutting head is stopped automatically by a
sensor at the left and right sides. In this case, the vinyl cutter is reset and it is
necessary to transfer the job to the plotter again.
38400
