Sebo 90406AM, Руководство пользователя

Страница: 10 / 16

10
MAINTENANCE
Figure 9
Figure 10
Figure 11
Figure 12
Always unplug vacuum from outlet before dismantling any part of the machine!
!
Ultra Filter Bag
Part #5093AM
Pre-motor
Microfilter
Part #5036AM
Exhaust Filter
Part #2846
Brush Roller G4
Part #5010AM
Brush Roller G5
Part #2838AM
Changing the Filter Bag -
Figure 9
To change the filter bag, pull the cover release flap for-
ward (#5 on page 6) and lift the cover (7) from the bag
housing.
The cover release flap must remain in a for-
ward “pulled-out” position to change filter bags and lock
them into place.
Squeeze the clamps on both sides of the
filter bag sealing plate (29), slide the plate from the hold-
er (30) and push the cap on to seal the bag. Slide the seal-
ing plate (29) of a new bag into the holder and push it in
firmly. Re-insert cover into the bag housing, push it for-
ward, then lock it in place by pushing down the cover
release flap. You may find it convenient to store the bag
cap inside the bag housing below the filter bag.
Changing the Pre-motor Microfilter -
Figure 10
The pre-motor microfilter (31) needs to be changed when
it becomes extremely dirty or clogged with dust, or after
approximately 20 filter bags have been used. To change
the pre-motor microfilter, pull the cover release flap (#5
on page 6) forward and lift the cover (7) from the bag
housing. Then, slide the filter out at the bottom. To
replace, lift the safety lever (32) and slide the new filter in
using the tracks as guides.
Changing the Exhaust Filter -
Figure 11
After 20 bags have been used, change the exhaust filter
(33). Remove the bag housing (6) from the power head by
pressing the housing release button (8). To remove the
exhaust filter, push the catch (34) and remove the filter
cover (35) and exhaust filter. Insert the new filter, replace
the filter cover then insert the bag housing back into the
power head.
Changing the Brush Roller -
Figure 12
To change the brush roller (37), push the button (36),
remove the side plate (38), turn the brush clockwise a
quarter of a turn, and pull the old brush roller out. Slide
the new brush roller into the brush housing and turn it
until it locks into position. While slightly pushing the but-
ton (36), press the side plate (38) back into the locked
position.