Sebart KatanaS 120 ARF, Инструкция по сборке

Страница: 3 / 43

Required radio, motor and battery
Radio equipment:
•
Minimum 5-channel radio system
•
5 digital servos metal gear, recommended JR PROPO DS 8411
•
2 servo extension 300mm, for elevator’s servos
•
4 servo extension 100mm, for aileron’s servos
Recommended electric motor for best performance:
•
Hacker A60-22S + MasterBasic90-Opto cont APC 20 x 10 E
Recommended Li-Po battery pack for best performance:
•
FlightPower 3700mAh 10S.….for unlimited 3D
•
FlightPower 4250mAh 10S…..for 3D, duration and precision
Additional required item, tools and adhesives
Tools:
•
Drill
•
Drill bits: 1,5mm; 2mm; 2,5mm; 3mm; 5mm; 6mm
•
Flat blade screwdriver
•
Phillips screwdriver large and small
•
Hobby knife
•
Masking tape
•
Paper towels
•
Rubbing alcohol
•
Sand paper
•
Soldering iron
•
synthetic oil
Adhesives:
•
5-minute epoxy
•
thin CA
•
medium CA
Warning
This RC aircraft is not a toy!
If misused, it can cause serious bodily harm and damage to property.
Fly only in open areas, preferably in official flying sites, following all instructions included with
your radio and motor.
This plane is a compromise between Aerobatics and 3D flying, and not a pylon racer.
It is built with a very light structure and for this reason we hardly recommend:
→ Do NOT fly your airplane at high speeds, because this may cause structural
failures or flutter due to the extremely large control surfaces.
3