13
LIFT MECHANISM:
Slide the link (item 1) inside the box of the right
support (item 2). Insert the pin (item 3) inside the link.
Insert the lift arm (item 4) on the pin (item 5) of the
right support and on the pin (item 3).
Secure the arm with one washer (item 6) and one hair
pin 4 mm (item 7).
Secure the pin in place with a flat washer (item 8)
and a hair pin 2.5 mm (item 9,
inserted from the
bottom to the top).
Secure the link to the pivot support (item 10) with a
pin (item 11) and a hair pin 2.5 mm (item 12).
Install the lift mechanism
ASSEMBLY
STEP 3
DRIVE MECHANISM PREPARATION:
SUPPORTS-GENERAL INSTALLATION:
Secure the left support (See table) with two carriage
bolts 3/8’’ x 3/4’’ (item 3) heads outside. Secure with
two flange nuts.
NOTE: Install only one support on the right side.
Side Support
Left 104345
(item 2)
Right
(If no interference with mower deck)
104345
(Item 2)
Right
(If 104345 interferes with mower deck)
104346
(item 1)
On the right side, install the mounting support (item 4)
inside the frame. Install on the outside (according to
chart) the support (item 1 or 2), two washers
7/16" (item 5) and secure with two hair pins (item 6).
NOTE:
On certain models of tractors, when the mower
deck is lifted to its highest position, it comes into
contact with the right hand support.
This installation will allow to remove the supports very
easliy at the end of the season.
Install supports (General installation).
Содержание CRAFTSMAN C 151 61672 3
