2
CONTENTS
INTRODUCTION/WARRANTY ..........................................2
SAFETY ...............................................................................2
INSTALLATION ................................................................3-4
OPERATION........................................................................4
MAINTENANCE ...............................................................4-5
PARTS .................................................................................5
INTRODUCTION
Please read our instructions before you install and use your
new pump; this will help you obtain full value and good ser-
vice from it. It will also help you avoid needless service costs
that result from causes we cannot control and cannot cover
in our warranty.
READ AND FOLLOW
SAFETY INSTRUCTIONS!
Carefully read and follow all safety instructions in
this manual or on pump.
This is the safety alert symbol.
When you see this
symbol on your pump or in this manual, look for one of the
following signal words and be alert to the potential for per-
sonal injury!
warns about hazards that
will
cause serious
personal injury, death or major property damage if ignored.
warns about hazards that
will
or
can
cause se-
rious personal injury, death or major property damage if ig-
nored.
warns about hazards that
will
or
can
cause
minor personal injury or property damage if ignored.
The word
NOTICE
indicates special instructions which are
important but not related to hazards.
1. To avoid risk of serious bodily injury and property dam-
age, read safety instructions carefully before installing
pump.
2. Follow local and/or national plumbing and electrical
codes when installing pump.
INSPECTION
This pump was thoroughly inspected, tested, and packaged
before shipment. Report any damage immediately to the
store where it was purchased.
INSTALLATION
1. Locate pump as close as possible to water being pumped.
Pump must be less than 10 feet (3m) above reservoir and
less than 25 feet (7.6m) to one side of reservoir.
2. To help priming, pour contents of one mineral oil packet
(supplied with pump) in inlet port. If packets are all gone,
cooking oil may be substituted.
3. Mount pump solidly on a stable platform.
NOTICE:
Protect motor from rain or washdown; it is en-
closed but not waterproof.
4. Make sure washer in inlet fitting is clean and in good con-
dition. If this joint leaks air, pump will not operate.
5. Install strainer to protect pump from large solids.
6. Attach inlet and discharge hoses to pump. Minimum di-
ameter of inlet hose is 1/2"(12.7mm). Be sure inlet hose
is airtight and that both hoses are free of kinks and re-
strictions.
7. When pumping from a well or stream, place suction end
of inlet hose a few inches above the bottom to prevent
the pump from sucking sand, silt or pebbles.
FULL ONE YEAR WARRANTY ON SEARS PORTABLE UTILITY PUMP
During the first year after the date of purchase, Sears will repair or replace this pump, free of charge, if defective in materials or
workmanship.
This warranty does not cover repairs on replacement parts necessary because of abuse or negligence including failure to in-
stall, adjust and operate this pump according to the instructions in the owner’s manual.
LIMITATION OF LIABILITY
SEARS WILL NOT BE LIABLE FOR LOSS OR DAMAGE TO PROPERTY OR ANY INCIDENTAL OR CONSEQUENTIAL LOSS
OR EXPENSE FROM PROPERTY DAMAGE DUE DIRECTLY OR INDIRECTLY FROM THE USE OF THIS PRODUCT.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclu-
sion may not apply to you.
WARRANTY SERVICE IS AVAILABLE BY SIMPLY CONTACTING THE NEAREST SEARS SERVICE CENTER/DEPART-
MENT IN THE UNITED STATES of AMERICA. For service outside the U.S.A., contact your local Sears Service Center or store.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Sears, Roebuck and Co., Dept. 817 WA, Hoffman Estates, IL 60179
