SL-155-5D/10D Models (integrated AIS)
6-13NM Marine Lanterns
Latest products and information available at
www.sealite.com
63
Reported messages
During operation the transceiver will output a variety of status messages relating to the
current operating state. These messages are for information only and do not represent a
fault condition.
Message Text
Description / Resolution
TX attempt failed
(msg 6 no payload
re-broadcast data)
A transmission of message #6 has failed as the payload data
required for this message was not provided (by either the extended
sensor interface, or an external system). The likely cause is a
configuration error relating to data capture.
TX attempt failed
(msg 8 no payload
re-broadcast data)
A transmission of message #8 has failed as the payload data
required for this message was not provided (by either the extended
sensor interface, or an external system). The likely cause is a
configuration error relating to data capture.
TX attempt failed
(msg 12 no payload
re-broadcast data)
A transmission of message #12 has failed as the payload data
required for this message was not provided (by either the extended
sensor interface, or an external system). The likely cause is a
configuration error relating to data capture.
TX attempt failed
(msg 14 no payload
re-broadcast data)
A transmission of message #14 has failed as the payload data
required for this message was not provided (by either the extended
sensor interface, or an external system). The likely cause is a
configuration error relating to data capture.
Standby blocked:
Off position
algorithm
The transceiver can’t enter standby (low power) mode because the ‘off
position’ algorithm has detected an off position condition. Moving the
transceiver within the configured operating radius will resolve this.
Standby blocked:
Acquiring GPS
The transceiver can’t enter standby (low power) mode because it
is currently acquiring a GNSS position fix. Standby operation will
resume when a fix is acquired.
Standby disabled
Standby mode (low power operation) is disabled by configuration.
Standby blocked:
USB connected
The transceiver will not enter standby (low power) mode whilst the
USB interface is connected to a PC.
Standby blocked:
Shell running
The transceiver will not enter standby (low power) mode whilst the
configuration shell is active.
Standby blocked:
Receivers enabled
The transceiver can’t enter standby mode if the current
configuration requires that the receivers are active.
Exit standby
Information only on exit of standby mode.
Entering standby
for xx seconds
Information only on entry to standby mode.
