myQ
®
REMOTE LED LIGHT
Model 827AU
NOTE:
The Remote Control supplied with your Remote LED Light is preprogrammed by the factory to the button shown in figure 1.
Installation
The myQ
®
Remote LED Light is designed to plug directly into a standard 240V outlet and not permanently wired. Consider installing close to an existing power
outlet. Nominal lumens is 1500, avoid directly looking at the lens when illuminated.
NOTE:
If installing light on lasterboard and a ceiling joist cannot be located, use wall anchors provided. No pilot hole is required for wall anchors.
1. Drill pilot holes 6-1/8" (15.6 cm) apart if mounting to joist. OR Screw in wall anchors 6-1/8" (15.6 cm) apart if mounting to lasterboard.
2. Determine the length of power cord needed to reach the nearest 240V outlet. Wind any excess cord around cord retainer on the top side of the light base.
Route the cord through the channel so the light mounts flush.
3. Open the light lens.
4. Mount the light with the screws provided.
5. Close the light lens.
6. Plug in the light to the 240V outlet.
NOTE:
The LED light is very bright and will blink while programming. DO NOT stare at the light while on a ladder.
To reduce the risk of SEVERE INJURY or DEATH:
• DO NOT alter the plug.
• Light is intended for indoor ceiling or wall mount applications ONLY.
Screws
Light Lens
Drywall
Anchors
6-1/8" (15.6 cm)
Cord Retainer
Channel
Channel
Wall Anchor (screw-in) (2)
Screw # 6G x 25mm (2)
Pre-
programmed
Button
Hardware Provided
Installation
Figure 1
Operation
Once the mains power is turned ON, the light can only be activated using S2.0 Remote Controls or the Merlin myQ
®
Internet app. A S 2.0
Remote Control is supplied with this kit.
If paired with a myQ
®
garage door opener the myQ
®
Remote LED Light can also automatically turn ON or OFF in simultaneously with the garage door opener’s
internal light to boost the illumination of the garage.
NOTE:
Wireless Wall Controls will not operate this device.
App Store is a service mark of Apple Inc. Google Play and the Google Play logo are require an additional accessory purchase or subscription fee.
Apple, the Apple logo, iPhone, and iPad are trademarks of Apple Inc.,
WARNING! This product contains a button/coin
cell battery.
•
The battery is hazardous.
•
Keep new and used batteries away from children.
•
Do not ingest battery. Chemical burn hazard.
•
If the coin cell battery is swallowed or placed
inside any part of the body, it can cause severe or
fatal injuries in 2 hours or less.
•
If the battery compartment does not close securely, stop using
the product and keep away from children.
•
If you think batteries might have been swallowed or placed
inside any part of the body, call the 24-hour Poisons Information
Centre on 13 11 26 in Australia, or the 24-hour National Poisons
Centre on 0800 764 766 in New Zealand, or seek immediate
medical attention.
•
Dispose of used coin/button cell batteries immediately and
safely. Flat batteries can still be dangerous.
