SEAL 65ProMD, Руководство пользователя

Страница: 52 / 63

52 7003338 - User Manual 65 Pro MD
d. Set the pressure while feeding the leader board.
e. Before the end of the leader board enters the nip, butt up the panel to be pre-coated.
When more panels have to be pre-coated feed them in continuously without any gap.
At the end, use a leader board again to finish. This prevents the adhesive from touching
the bottom roller.
f. Butt up and feed the last leader board until the previous panel is out of the nip.
CAUTION:
Do not cut film close to or on the rollers. This will damage the silicone
coating of the rollers and will void the warranty.
g. Cut this panel free.
h.
Back-up the leader board using the reverse.
i. Cut the film using a Zippy cutter with a covered blade.
After removing the release liner from the pressure sensitive mounting film, the board has
an adhesive coating ready to mount an image.
5.5.3 Single-sided lamination
Images are laminated single-sided using carrier (or release) boards. This laminate can be
a heat sensitive laminate or a pressure sensitive adhesive with release liner.
•
The image is put on the carrier board with the image side up.
•
All steps in this process are the same as when pre-coating a board.
5.5.4 Double-sided lamination
Encapsulating images with cold laminates is called double-sided lamination (and is
normally not done with panels).
a. Load and web laminating film in the upper and the lower section.
b. Stick a leader board to the films and feed it through the nip.
c.
When the leader board is completely out of the nip, lower the upper roller onto the
bottom roller (nip setting = 0).
d.
Now feed the images into the nip, allowing a gap between them.
e. Cut the film with the blade cutter when the images are clear of the rollers.
To unload the machine:
f.
Cut both films along the splitter bar using an enclosed blade cutter.
g. Open up the nip and remove the film between the rollers.
5.5.5 Encapsulation
Encapsulation is the term for sealing an image with heat activated laminates on both sides.
Note:
The heated rollers need time to reach their set temperature (e.g. from room temperature
to maximum takes approximately 1 hour). It is recommended to let the machine run at
low speed, to avoid uneven hot spots.