Seagull Models P-47D Thunderbolt 60, Инструкция по сборке

Страница: 35 / 87

35
4
.
5
.
- On the fie wall has the location for the throttle
pusshrod tube (pre-drill).
- Slide the pushrod tube in the fiewall and guide it
through the fuel tank mount. Use medium C/A to
glue the tube to the fiewall and the fuel tank mount.
- Connect the Z-bend in the 450mm throttle push-
rod to the outer hole of the carburetor arm.
- Slide the throttle pushrod wire into the tube. Po-
sition the engine between the mounts. Use four
M4x30mm machine screws to secure the engine to
the mount as shown.
4x30mm
- Reinstall the servo horn by sliding the connec-
tor over the pushrod wire. Center the throttle stick
and trim and install the servo horn perpendicular
to the servo center line.
- Move the throttle stick to the closed position and
move the carburetor to closed. Use a 2.5mm hex
wrench to tighten the screw that secures the throt-
tle pushrod wire. Make sure to use threadlock on
the screw so it does not vibrate loose.
6
.
COWLING
- Please see below pictures.
1 .
2
.