Jumper 25
Instruction Man u al
6
1) Using a modeling knife, remove
the cov er ing from over the two main gear
mount ing slots lo cat ed in the bottom of the
fu se lage.
2) Insert the 90º bend of one main gear
wire into the predrilled hole in one mounting
slot.
3) The land ing gear wire is held in place
us ing two nylon landing gear straps and four
3mm x 12mm wood screws.
The straps should be lo cat ed equal dis tance
from the inside and outside ends of the wire.
4) Using the two landing gear straps as
a guide, mark the locations of the four 3mm
x 12mm mount ing screws onto the fuselage
sur face.
5) Remove the two straps and the gear
wire. Drill four 3/32” pilot holes into the wing
for the wood screws.
INSTALLING THE MAIN GEAR WHEELS
8) Slide one wheel collar with 3mm x
6mm set screw onto each axle. Push the
wheel collars on as far as they will go and
tight en the set screws.
Be careful not to overtighten the set
screws. Over tight en ing may cause the
threads to strip.
INSTALLING THE MAIN GEAR WIRES
