Seagate DiamondMax 17, Руководство пользователя

Страница: 25 / 60

3-10 Maxtor DiamondMax 17 80-160GB Serial ATA Hard Disk Drive
Installation
Figure 3-7 Crosswise Airflow Cooling
3.6 FOR SYSTEMS WITH AN ATA ADAPTER BOARD
To install the DiamondMax 17 80-160GB Serial ATA hard disk drive in an AT-
compatible system without a Serial ATA connector, you need a third-party IDE-
compatible adapter board.
To connect the DiamondMax 17 80-160GB Serial ATA drives, use the Serial ATA
cable, 1 meter long or shorter. The Serial ATA cable connectors are keyed to ensure
proper orientation.
3.6.1 Adapter Board Installation
Carefully read the manual that accompanies your adapter board before installing it.
Make sure that all the jumpers are set properly and that there are no address or signal
conflicts. You must also investigate to see if your AT-compatible system contains a
combination floppy and hard disk controller board. If it does, you must disable the
hard disk drive controller functions on that controller board before proceeding.
Once you have disabled the hard disk drive controller functions on the floppy/hard
drive controller, install the adapter board. Again, make sure that you have set all
jumper straps on the adapter board to avoid addressing and signal conflicts.