Seagate DiamondMax 17, Руководство пользователя

Страница: 10 / 60

Maxtor DiamondMax 17 80-160GB Serial ATA Hard Drive 1-3
Introduction
The typographical and naming conventions used in this manual are listed below.
Conventions that are unique to a specific table appear in the notes that follow that table.
Typographical Conventions
– Names of Bits: Bit names are presented in initial capitals. An example
is the Host Software Reset bit.
– Commands: Interface commands are listed in all capitals. An example
is WRITE LONG.
– Register Names: Registers are given in this manual with initial
capitals. An example is the Alternate Status Register.
– Parameters: Parameters are given as initial capitals when spelled out,
and are given as all capitals when abbreviated. Examples are Prefetch
Enable (PE), and Cache Enable (CE).
– Hexadecimal Notation: The hexadecimal notation is given in 9-point
subscript form. An example is 30
H
.
– Signal Negation: A signal name that is defined as active low is listed
with a minus sign following the signal. An example is RD–.
– Messages: A message that is sent from the drive to the host is listed in
all capitals. An example is ILLEGAL COMMAND.
Naming Conventions
– Host: In general, the system in which the drive resides is referred to as
the host.
– Computer Voice: This refers to items you type at the computer
keyboard. These items are listed in 10-point, all capitals, Courier font.
An example is FORMAT C:/S.
1.4 REFERENCES
For additional information about the ATA interface, refer to the latest revision of the
draft standard on the internet at http://www.t13.org/ using the link under
“1532D AT Attachment-7 with Packet Interface (ATA/ATAPI). For additional
information about the Serial ATA interface, refer to the latest specifications on the
internet at http://www.serialATA.org using the “specs and design guidelines” link.