CLEARING JAMS
To clear a jam, remove the Hopper Assembly.
1. To Remove the Hopper Assembly.
A.) Unlock and open the Front Door, unplug vendor.
B.) Push the Thumb Tabs up, and tilt the Coin Hopper forward. (Fig. 10)
C.) Lift and remove. Note: The Coin Hopper is still connected to the Coin
Validator by the Ribbon Cable that can be unplugged from the basee. (Fig.12)
D.) Clear jam and reassemble.
CLEANING
Your Coin Validator needs to be cleaned only when the Coin Validator will no longer read coins.
1. Cleaning the Optics. You will need cotton swabs (Q-tips), and a mild soap and water solution.
A.) Unlock and open the Front Door.
B.) Tilt the Coin Hopper open, there are two (2) Lenses on the Flap and
two (2) Lenses inside the Coin Hopper. (Fig. 11)
C.) Swab the Lenses with the solution, and reassemble.
REMOVAL OF THE COIN VALIDATOR
1. To Remove the Coin Validator.
A.) Remove the Coin Hopper as above.
B.) Loosen the three (3) Mounting Screws. (Fig. 12)
C.) Disconnect Wiring Harness.
D.) Lift Coin Validator and remove.
BILL VALIDATOR
Note:
The manufacturer's Bill Validator manual is packed with your vendor. The following is intended as an addendum to the
manufacturer's manual.
Figure 10
Thumb Tabs
Thumb Tabs
Tilt
Figure 11
Coin Validator Lenses
Lenses (4)
