Seaga VC6000, Руководство оператора, Страница: 7 / 13

DRIVER MOTORS
Each selection is vended by the action of the Driver Motor. The Driver Motors are clipped to the rear of each Product Tray.
In the rare event of a jam a Driver Motor may need to be returned to its home position. The home position is when the shaft of
the Helix Coil that is held by the Driver is vertical, with the end of the shaft pointing down. (Fig. 5)
1. To "Home" a Driver Motor.
A.) Unlock and open the Front door to access the Circuit board, and
enter Service Mode by pressing the Red Service Mode Button (Fig. 2)
B.) Cycle through the Service Mode until the display reads “SLCT”.
C.) Enter the letter and number of the motor you wish to home. The motor
will rotate to it’s home position.
2. To Remove a Driver Motor.
A.) Unlock and open Front Door
At “Home” switch is
not depressed
Figure 6 Gray and White Driver Motor
Driver Motor
White Wire with Gray
Stripe on 10 select
trays; Black Wire on
5 select trays
Color Wire
varies by Product Tray.
Top 5 select Red
Center 5 select Orange
Bottom 10 select Yellow.
Color Wire
varies by Product
Tray and left to right.
Top Blue, Purple, Brown, Gray,
White
Center Blue, Purple, Brown, Gray,
White
Driver Motor
(S) White Wire with
Gray Stripe on 10
select tray; Black
Wire on 5 select tray
Color Wire
(+)
varies by Product
Tray and left to
right.
Top Blue, Purple,
Brown, Gray, White
Center Blue, Purple,
Brown, Gray, White
Bottom Blue,
Purple, Brown, Gray,
White, White / Red
stripe, White /
Orange stripe, White
/ Yellow stripe, White
/ Green stripe, White
/ Blue stripe
Color Wire
(-)
Color varies by Product Tray.
Top 5 select Red
Center 5 select Orange
Bottom 10 select Yellow.
Black Driver Motor
White Driver Motor
Driver Motor
Wire Harness